NARDA FieldMan, User Manual

Page: 44 / 126

7 Device settings
44
FieldMan Narda
7.1 Setting types
On this device, a distinction is made between
Device settings
and
Measurement set-
tings
.
7.1.1 Device settings
7.1.2 Measurement settings
7.1.3 Resetting settings
Device settings include all parameters that affect the general device behavior or the form
of the display, but do not affect the measurement itself. The device always remembers
the last used device settings, stores them on the SD card and loads them the next time
the device is started. Device settings, with the exception of
EXPERT SETTINGS
, are not
saved in a setup.
Open device settings:
⇒
Press SK4 .
For information on device settings, see the following sections:
• GENERAL SETTINGS on page 45
•
EXPERT SETTINGS on page 47
• POSITION AND TIME on page 48
•
CONNECTIVITY on page 50
• INFORMATION on page 51
•
SETUPS on page 53
• DATA LOGGER on page 91
These include all parameters that influence a measurement. They are grouped under the
softkey
SK2
and are supplemented by the settings under
EXPERT SETTINGS
(see
7.5 EXPERT SETTINGS on page 47 ). Only measurement settings are used for saving
and loading a setup.
Open measurement settings:
⇒
Press
SK2
in the respective operating mode.
Information on the measurement settings can be found in the description of the respec-
tive operating modes.
Via
Factory Reset
(see 7.3 GENERAL SETTINGS on page 45 ), both setting types can
be reset to the delivery state.