Napoleon ultra chef 485 series, User Manual

Page: 22 / 100

22
www.ultrachefgrills.com
4 x N570-0091 (1/4-20 X 1/2”)
3/8”(10mm)
Correct Assembly
9. Grill Head Installation
L485RSIB MODELS -
Are equipped with internal lights. To avoid assembly difficulties, prior to mounting grill head
remove the zip tie holding the wire connectors in place. (Take care when removing the tie not to damage the wires).
Ensure the wires drop inside the cart and do not become pinched between the grill head and the cabinet when mounting
the grill head.
PROPANE ONLY -
To avoid assembly difficulties, prior to mounting the grill head, remove zip tie holding regulator
up under control panel. This was installed at the factory to protect the regulator hose during shipping and is no longer
required. (Take care when removing the tie not to damage the hose). Ensure the regulator drops into the small opening,
between the tank heat shield and the right side of the cabinet.
Lift grill head and place on assembled cart, lining up holes in top of side cart panels with holes in bottom of base. Fasten
from inside using (4) 1/4-20 x 1/2” screws, two per side.
Two people are required for this step.
Incorrect Assembly
10. Transformer / Rotisserie Mount Installation
(RSIB MODEL)
Connect the two wire connectors from the lights to the two wire connectors coming from the transformer. Install rotisserie
mount bracket to left side of barbecue as shown using (2) 1/4 – 20 x 3/8” screws.
Battery Pack / Rotisserie Mount Installation
(RSB MODEL)
Install battery pack below vent slots on left hand panel using magnet supplied with battery pack. Plug wire from LED
(lights) located underneath control panel into wire from battery pack. Install rotisserie mount bracket to left side of
barbecue as shown using (2) 1/4 – 20 x 3/8” screws.