W415-1476 / C / 10.03.17
25
EN
7.1 OPTIMUM BURN METHOD
For optimal emissions performance and efficiency follow these simple guidelines when using your appliance:
A.
Maintain a 2" (51mm) deep, hot, glowing red coal bed.
B.
Burn dry seasoned wood with less than 20% moisture content and burn so that the glass door
remains clean.
C.
A stove thermometer 18" (457mm) up on the single wall stove pipe should indicate 350°F (176°C) as
an average temperature.
D.
Maintain a minimal trace of smoke coming from the chimney when the appliance is burning as
intended.
E.
Inspect and replace all necessary components such as gaskets, manifolds, glass and other
components which may affect the overall appliance performance.
F.
Ensure an adequate draft to control burn rate and temperature.
Refer to “OPERATION” and “MAINTENANCE” sections for detailed information.
Draft is the force which moves air from the firebox up through
the chimney. The amount of draft in your chimney depends on
the length and diameter of chimney, local geography, nearby
obstructions and other factors including the amount of heat
generated by the fire which can be measured by an appliance
thermometer.
Adjusting the air control regulates the temperature. The draft can
be adjusted from a low burn rate with the handle in fully, to a high
burn rate with the handle fully out.
Inadequate draft may cause back-puffing into the room through
the appliance and chimney connector points and may cause
plugging of the chimney. Too much draft may cause an excessive
temperature in the appliance, glowing red appliance parts or
chimney connectors or an uncontrollable burn which can lead to a
chimney fire or permanent damage to the appliance.
Do not operate your appliance for longer than 30 minutes with the draft control on “HIGH” (fully open).
HI
G
H
LO
W
ASH LIP
7.2 AIR CONTROL
!
WARNING
7.3 FIRE EXTINGUISHERS / SMOKE & CARBON MONOXIDE DETECTORS
91.1A
All homes with a solid fuel burning appliance should have at least one fi re extinguisher in a central location,
known to all and at least one smoke detector and carbon monoxide (CO) detector in the room containing the
appliance. If the smoke detector sounds an alarm, correct the cause but do not de-activate or relocate the
smoke detector. If the carbon monoxide detector sounds an alarm, immediately vent the area, evacuate and
call your local fi re department.
THIS WOOD APPLIANCE HAS A MANUFACTURER-SET MINIMUM LOW BURN RATE AND MAXIMUM
HIGH BURN RATE THAT MUST NOT BE ALTERED. IT IS AGAINST FEDERAL REGULATIONS IN THE
UNITED STATES TO ALTER THIS SETTING OR OTHERWISE OPERATE THIS WOOD APPLIANCE IN A
MANNER INCONSISTENT WITH OPERATING INSTRUCTIONS IN THIS MANUAL.
NOTE: Always check your smoke and CO detectors are working properly.