W415-4002 / 08.11.21
EN
10
operatingyourappliance
3.0 operation
In order to overcome the dense cold air that can build up in the venting system during extreme cold conditions, we recom-
mend turning on and off your appliance on the low fl ame setting and with the split fl ow function for the rear burner turned
off (if equipped). Once the appliance has operated for a minimum of 5 to 10 minutes on low, typically the fl ame can then be
increased to the high setting and the rear burner (split fl ow function) can be turned on (if equipped). This will help to avoid un-
necessary shutdowns while the insert is warming up and trying to overcome the cold air block in the venting system.
3.1 extremecoldlightinginstructions
• Do not turn on if children or other at risk individuals are near the appliance.
• This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the
pilot by hand.
• Before operating, smell all around the appliance area for gas and next to the fl oor because some gas is
heavier than air and will settle on the fl oor.
• Do not use this appliance if any part has been under water. Immediately call a qualifi ed service technician
to inspect the appliance and replace any part of the control system and any gas control which has been
underwater.
FORYOURSAFETYREADBEFORELIGHTING
WHATTODOIFYOUSMELLGAS
LIGHTINGINSTRUCTIONS
TOTURNOFFGAS
A.
Stop! Read the above safety information on this label.
B.
Remove batteries from the transmitter and set thermostat to lowest setting, if
equipped.
C.
Turn off all electrical power to the appliance.
D.
Open the glass door, if equipped.
E.
Turn the manual shut-off valve clockwise to the “OFF” position. (Shut-off valve is
located on the fl ex connector).
F.
Wait fi ve (5) minutes to clear out any gas. If you smell gas including near the
fl oor,
STOP!
Follow the instructions above in the “WHAT TO DO IF YOU
SMELL GAS” section. If you don’t smell gas; close the glass door and go to
the next step.
G.
Turn the manual shut-off valve counter clockwise to the “ON” position.
H.
Turn on all electrical power to the appliance and re-install the batteries into the
transmitter. Set thermostat to desired setting, if equipped.
I.
Turn on the remote wall switch to the appliance.
J.
If the appliance will not operate, follow instructions “TO TURN OFF GAS” and
call your service technician or gas supplier.
A.
Set thermostat to lowest setting, if equipped.
B.
Turn off the remote wall switch to the appliance.
C.
Turn off all electric power to the appliance if service is to be performed.
D.
Turn manual shutoff valve clockwise to the “OFF” positon. Do not force.
• Turn off all gas to the appliance.
• Open windows.
• Do not try to light any appliance.
• Do not touch any electric switch; do not use
any phone in your building
• Immediately call your gas supplier from a
neighbour’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call
the fi re department.
• If you do not follow these instructions exactly, a fi re or explosion may result causing property damage, personal
injury, or loss of life.
• If applicable, always light the pilot whether for the fi rst time or if the gas supply has run out with the glass door
opened or removed.
When lit for the fi rst time, the appliance will emit an odor for a few hours. This is a normal temporary condition
caused by the “burn-in” of paints and lubricants used in the manufacturing process and will not occur again. After
extended periods of non-operation, such as, following a vacation or warm weather season, the appliance may
emit a slight odor for a few hours. This is caused by dust particules in the heat exchanger burning off. In both
cases, open a window to suffi ciently ventilate the room.
This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the
pilot by hand.
note:
