13
WS-415-090 / 04.03.00
LOG PLACEMENT
PHAZER
TM
logs and glowing embers (available as an op-
tion from your Napoleon dealer), exclusive to Napoleon
Fireplaces, provide a unique and realistic glowing effect
that is different in every installation. Take the time to care-
fully position the glowing embers for a maximum glowing
effect.
1.
Place the front log, as shown, centered along the inside
front edge of the burner tray.
2.
Place the back log onto the log support bracket, located
on the rear wall of the combustion chamber, pushing it as
close to the firebox wall as possible.
3. & 4.
Set the two smaller logs into the pockets and
grooves of the front and back logs, respectively.
FIGURE 28
FINISHING
POSITIONING THE LOGS IMPROPERLY WILL CAUSE
FLAME IMPINGEMENT AND CARBONING.
Log colours may vary. During the initial use of the fireplace,
the colours will become more uniform as colour pigments
burn in during the heat activated curing process.
OPTIONAL GLOWING EMBERS
Tear the embers into pieces and place beneath the front
log covering all of the burner area beneath and in front of
the hollowed out section of the log. Care should be taken
to shred the embers into thin, small irregular pieces as
only the exposed edges of the fibre hairs will glow.
THE EMBER MATERIAL WILL ONLY GLOW WHEN EX-
POSED TO DIRECT FLAME; HOWEVER, CARE SHOULD BE
TAKEN TO NOT BLOCK THE BURNER PORTS.
Blocked burner ports can cause an incorrect flame pat-
tern, carbon deposits and delayed ignition.
PHAZER
TM
logs
glow when exposed to direct flame. Use only certified "glow-
ing embers" and
PHAZER
TM
logs available from your Na-
poleon / Wolf Steel Ltd. dealer.
1
2
3
4
FIGURES 27
Summary of Contents for GD27 - N
Page 23: ...23 WS 415 090 04 03 00 NOTES...