53
EN
MXA51006
(85956141BM03SJ)
The light function can be deactivated in the same way.
The activation and deactivation of the light function can
be done only in the standby mode. The light function is
completely deactivated if the batteries are low, except if
there is an alarm in night mode.
Switching the light on and off
The light is switched on and off using the capacitive switch
located in the middle of NANNY logo (symbol no. 3 in Fig.
3). The light is switched on and off by touching the light’s
capacitive switch which is located in the middle of the NANNY
logo. Place your fi ngertip on the center of the NANNY logo
and leave it attached for at least 1 second (Fig. 5b). There
is no need to press the switch, just place your fi nger on the
surface.
The light is on for a period of 30 secs
. If you place your
fi nger on the capacitive switch again
within 20 secs
of
switching on, the lamp goes out.
After 20 secs
, the lamp
will gradually dim. If you place your fi nger on the capacitive switch again as it dims,
the light will be restored for another 30 secs, otherwise it will go out after 30 secs.
If the alarm is triggered in night mode, the lamp will turn on automatically.
2.2.3 MONITORING
ROOM
TEMPERATURE
The evaluation unit is equipped with a room temperature sensor. It serves to indicate the
room is overheated, which may be one of the causes of sudden infant death syndrome.
The device can thus indicate a room temperature that is quite likely uncomfortable,
however, responsibility for the temperature and quality of the environment lies with the
parent or other caregiver (monitor operator).
The temperature range is indicated by a fl ashing indicator light with the thermometer
symbol:
Flashing
blue
= the room temperature is
below 16.5 °C
. It is a cooler environment, but it
may be comfortable for you and your baby.
Flashing
orange
= room temperature is
higher than 28 °C
. It is advisable to reduce it, for
example by airing or turning down the heating, to prevent the baby from overheating.
2.2.4 DAY AND NIGHT MODE
The device is equipped with an optical sensor to detect day and night, or darkness.
Thanks to this, the light diodes light up at night with a lower intensity than during the day
to ensure parents or other caregivers have a good night’s rest.
Day and Night mode switches automatically.
Fig. 5b – Switching the light on
and off
The lamp cannot be switched on when the battery voltage is low, which is indicated by
repeated rapid fl ashing of the low battery indicator light.
Summary of Contents for BM-03
Page 68: ...BM 03 MXA51006 85956141BM03SJ...
