54
EN | BM-03 Baby breathing monitor
MXA51006
(85956141BM03SJ)
3. INSTALLATION
Fig. 7 Securing the connecting cable
Fig. 8 Inserting the batteries
Fig. 9 Connecting the
connecting cable to
the control unit
Neither the sensor pad nor the control unit need to be specially cleaned or disinfected
after unpacking. Before using the monitor, make sure that all parts are undamaged. The
device does not require temperature adaptation in connection with its installation and
subsequent repeated use.
1.
Place the sensor pad under the mattress together
with a suitable insulating layer against liquid
penetration in the places where the baby will be
lying. The pad must be placed on a fl at surface
with the top print facing up and must not be bent.
If the cot only has a slat base, support the pad with
a solid board. The board does not have to cover
the entire lower part of the bed - it is enough if
it exceeds the area of the pad by about 3 cm on
each side.
2.
Route and secure the connecting cable so that the
child cannot pull on it and it does not form loose
sections or loops. If you do not use the entire length
of the cable, roll up the unused part and tighten it
tightly with a tie wire. Keep the roll out of the reach of
children.
3.
Remove the battery cover and insert the batteries. The battery compartment has
the polarity marked inside for inserting the battery.
4.
Connect the connecting cable to any socket in the
control unit. The connector must click and hold when
inserted.
Fig. 6 Location of the sensor pad
Summary of Contents for BM-03
Page 68: ...BM 03 MXA51006 85956141BM03SJ...
