Nanni QLS 65T, User Manual

Page: 52 / 80

52
DRAINING THE ENGINE OIL
OIL DRAINING:
1. Start the engine and let it warm few minutes to
render oil more fluid to ease suction.
2. Stop the engine and remove the key from the panel.
3.
Open the side oil filler to ease up draining.
4. Drain all used oil out from the pan.
5. Disconnect the oil drain pump and replace the cap
on the drain pipe.
Above picture: pan draining oil - close up.
Above picture: open the side oil filler.
Draining with external oil pump:
Regarding the amount of oil to drain, oil draining is
better performed through an external pump connected
to the oil check dipstick duct.
S08 MAINTENANCE
CHANGING THE OIL FILTER
Replace the oil filter every time the engine oil is drained.
1. Remove the oil filter with a filter wrench tool. Turn the
filter counter-clockwise (CCW). Remove the gasket.
2. Clean the mating surface in order to prevent
impurities from entering the engine.
3. Apply a film of oil on the new gasket. Screw the new
filter by hand with the new gasket. When the gasket
contacts the mating surface, turn the filter a half turn.
4. Fill with proper amount of new oil. Check for leaks
and check the oil level.
5. Start the engine and let it operate few minutes at idle.
Check if the oil pressure warning lamp turns off.
6. Stop the engine, wait for the engine to cool down and
check the oil level. Top up if necessary.