N&W Global Vending Snakky RY, Installation Manual

Page: 35 / 52

© by N&W GLOBAL VENDING S.p.A.
31
06 2007 294-00
pRogRammiNg mENu SummaRy
The machine can function in 3 different operating mo -
des:
- Normal vending mode
- filler menu
- technician menu
In order to access the programming menus, press the
programming button located on the CPU board (see fig.
29):
The machine goes into “Filler Menu” mode.
When pressing button
�
the machine goes from “Filler
Menu” to “Technician Menu” and vice versa.
Fig. 29
Programming access button 1-
RS232 serial port 2-
SuRfiNg modE
The buttons shown in the figure are used for surfing
through the different menus:
Scrolling buttons up
�
and doWN
�
the
�
and
�
scrolling buttons are used for moving from
one programming menu item to the next one, located in
the same level, and at the same time change the status
or the numeric value of the corresponding functions.
Confirm / enter button
�
The confirm/enter button
�
is used for moving to the
lower level or for confirming a value after being entered
or changed.
Exit button
�
The exit button
�
is used for returning to the higher level
or for exiting a change field of a function. When reaching
the highest level in the menu, this button is pressed for
going from the technician menu into the Filler menu and
vice versa.
inserting the values
When the control software requests the entry of alpha -
numeric characters the buttons take on the following
functions:
the confirm button
-
�
is for changing / entering the first
character, then for confirming it and going to the next
character.
the
-
�
and
�
buttons are for scrolling the available
values.
Entering the password
The passwords are 5-digit numeric codes.
When the control software requests the entry of a pas -
sword the keypad takes on the following numeric values.
Fig. 30