FLAMIN’ FINGER
™
Operator’s
Manual
9
Problem
Probable Cause
Solution
No motion sound.
1)
No AC power.
1)
Check AC input plug on switching
power supply. Verify PS switch is
ON. Check DC output voltage at 9-
pin connector. RED to BLK should be
5+/-.15VDC. ORG to BLK should be
12VDC -0/+1.8VDC. If 12VDC is bad,
check for output shorts by removing
load connectors one at a time (ref.
overall wiring diagram in Appendix).
If loads are OK, or if 5VDC is out of
adjustment, (4.95 to 5.05), adjust
power supply.
2)
No DC power.
2)
Check AC input plug on switching
power supply. Verify PS switch is
ON. Check DC output voltage at 9-
pin connector. RED to BLK should be
5+/-.15VDC. ORG to BLK should be
12VDC -0/+1.8VDC. If 12VDC is bad,
check for output shorts by removing
load connectors one at a time (ref.
overall wiring diagram in Appendix).
If loads are OK, or if 5VDC is out of
adjustment, (4.95 to 5.05), adjust
power supply.
3)
Main PCB problem.
3)
If main PCB rack is suspected bad,
verify by swapping with known good
unit. If service is req’d, contact your
Distributor.
No audio.
1)
Cables bad, or incorrectly
connected.
1)
Check connectors on MAIN PCB.
2)
Sound output set too low.
2)
Adjust audio volume in OPTIONS
under MAIN MENU. Ref. GAME
VOLUME or ATTRACT VOLUME.
Distorted audio.
1)
Volume set too high.
1) Adjust in OPTIONS under MAIN
MENU. Ref. GAME VOLUME or
ATTRACT VOLUME.
2)
Main PCB problem.
2)
Main PCB rack requires service.
3)
Incorrect speaker impedance.
3)
Verify 4 ohm speakers.
APPENDIX A:
PARTS LIST
Summary of Contents for FLAMING FINGER
