NAMCO FLAMING FINGER, Operator'S Manual

Page: 7 / 20

FLAMIN’ FINGER
™
Operator’s Manual
3
4.0 INSTALLATION
Note: Shipping damage may void the warranty. In case of shipping damage, contact your
distributor and the transportation carrier immediately.
1. Unpack the game.
2. With the game in its installation position, lower the leveler pads as required
to eliminate any tilting of the game.
3. Plug in the main AC power cord, and turn the game ON.
4.1 LINKING
Games are shipped with 2 link cables. One is plugged into the output jack on the main pcb,
and runs to one side of a female-to-female (f-f) connector mounted on top of the coin box,
accessible through the coin door. A second cable is plugged into the other side of the
female-to-female connector and runs to the input jack on the main pcb. The link cables
must be installed for proper game function.
Linking can be done using one of two methods.
SEE APPENDIX C FOR LINKING DIAGRAMS
1. SEQUENTIAL. Recommended for 2 or 3 games, where the link cable can reach
from the last game to the first game in the line of linked games.
To link 2 or 3 games, unplug the link cable from the output side of the f-f connector of
game 1. Route it through the small round hole in the back of the cabinet, into the hole in
the back of the cabinet of game 2. Unplug the link cable plugged into the output side of
the f-f connector in game 2 and plug in its place the link cable just routed from game 1.
Route the cable just unplugged from game 2 out of the cabinet and into the game 1
cabinet, and plug it into the output side of the f-f plug in game 1.
THE LAST LINKED GAME IN THE CHAIN OF GAMES MUST CONNECT BACK TO THE
FIRST GAME IN THE CHAIN.
2. STAGGERED. Recommended for 4 or more games.
This method utilizes staggered routing, or every other game is linked. After the initial
input-to-output linking of games 1 and 2, the odd number games are linked together,
and the even number games are linked together.
SEE APPENDIX C FOR LINKING DIAGRAMS