Page
1-3 Connecting the Seat Assemblies to the Tower Assembly
1)
Insert the seat assembly from the side of the tower unit so that the front legs of
the tower unit are underneath the seat assembly.
2)
Remove the four security screws (M5x12) from the bottom front of the tower unit,
and remove the lower front cover (F). Temporarily fasten the seat unit with two
hex head bolts (M10x25), flat washers and safety washers. (Do not tighten)
3)
Remove the four security screws (M5x12) from the bottom rear of the tower unit,
and remove the lower rear cover (S). Temporarily fasten the ride unit with four
hex head bolts (M10x25), flat washers and security washers.
4)
Tighten all of the hex head bolts (M10x25).
5)
Connect the connectors between the seat assembly and tower unit.
6)
Connect the other seat assembly in the same way.
7)
Replace the front and rear covers (F), (S) taking care not to trap or pinch any
wiring.
[NOTE]:
When connecting the seat asseblies to the tower unit take care not to
trap any wires.
4