Nakayama PB6500, Manual

Page: 29 / 34

- 11 -
4. Set the engine stopping device to open:(F10)
5. Depress the throttle trigger 3 to 5 times;
(1) Engine stopping device
(2) Throttle trigger
6. With one hand on the power engine head and other
gripping the pull starter lever, firmly grasp the start
lever and rapidly pull the lever until the engine
starts.
7. After the engine starts, or 4 to 6 pulls, move the
choke lever to open position, Restart the engine if
necessary and allow unit to warm up at idle for
several minutes.
8. After the engine has warmed up, grip the throttle handle. Depress the throttle
trigger gradually to increase engine RPM to operating speed.
When restarting immediately after stopping the engine, release the throttle
lever return to the idling position.
1. While holding the unit firmly, pull out the starter rope quickly
2. After the engine has started, open the choke gradually.
3. Allow the engine to run for 2 to 3 minutes to warm up.
•
STOPPING THE ENGINE
1. Release the throttle trigger and allow engine return to idle before shutting off the
engine.
2. Push stopping device until engine has completely stopped.
"
1. During operation, always grip the support handle firmly with both right and left
hands.
"
2. Hold the trimmer/cutter handle firmly and depress the throttle trigger slowly to
accelerate the engine.
"
3. NEVER remove your hands from the trimmer/cutter handle bar when unit is
working.
"
4. The engine continues running even the blade or nylon cutter have stopped due
to an obstruction. If this occurs, stop the engine and remove the obstruction
before you continue.
NOTE
WARNING