www.NakayamaTools.com
14
WARNING
:
Do not continue to press the On/Off switch after the machine has been
automatically switched off.
The battery can be damage.
The battery is supplied partially charged
.
To ensure full capacity of the battery, completely
charge the battery in the battery charger before using your power tool for the first time.
A
battery
that is new or has not been used for a longer period does not develop its full
capacity until after approx. 5 charging/discharging cycles.
W
hen the machine can not rotate while the On/Off switch is pressed, then the battery has
no enough
capacity and should be charged.
Plug the mains plug of the adaptor 9 into a socket outlet and the adaptor plug 8 into the
socket
6.
At this time, the battery charge
-
control indicator 7 lights up
red
.
The battery
charge
-
control indicator indicates the
charging progress. The indicator lights up red
during the charge procedure. The battery is completely charged when the indicator
lights up green.
D
isconnect the battery
charger from the mains supply when not using it for longer periods.
Protect the battery charger against moisture!
Operation
N
OTE
:
Remove the blade guard first before operating the machine.
Switching On and Off
To start the machine,
remove the blade guard first and then push
the lock
-
off button
③
to “ON”
position, pull the locking retractors
⑤
backward,
then the moving blade
②
will
move back until to the fully open position.
P
ress the On/Off switch
④
at the same time.
When the machine is running,
m
aintain the On/Off switch
state
.
The moving blade will go
forward until
to the fully close position, and then stop.
To switch off the machine, release the On/Off switch
④，
Simultaneously do not release the
locking retractors
⑤
.
The moving blade will move back until to the fully open position, and
then stop.
Maintenance and Service
4.
Maintenance and Cleaning
Warning! Always push
the lock
-
off button
③
to “
OFF
” position.
For safe and proper working, always keep the machine clean.
Always wear protective gloves when using, adjusting or cleaning the machine.
Regularly check for obvious defects such as loose fixings, and worn or damaged components.
5.
Changing the Moving Blade
