Nakayama BL4300, Owner'S Manual

Page: 27 / 31

13
WWW
.N
AKAYAMA
T
OOLS
.
COM
Tensioning rewind spring
• Make a loop in the unwound starter rope and use it to turn the rope rotor six full
revolutions in the direction of the arrow (see illustration).
• Hold the rotor steady - .straighten the twisted rope.
• Release the rotor and let go of rope slowly so that it winds onto the rotor.
•
The starter grip must sit firmly in the rope guide bush. If the grip droops to one side:
increase spring tension by one additional turn.
When the starter rope is fully extended it must be possible to rotate the rotor at least
another half turn. If this is not possible, the spring is over tensioned and could break.
Take one turn of the rope off the rotor.
• Fit the starter cover on the engine.
•
Tighten down the screws firmly.
•
Move the stop switch to OFF
Storing the Machine
For periods of about 3 months or longer
•
Drain and clean the fuel tank in a well ventilated area.
•
Drain and clean the container.
•
Run engine until carburettor is dry - this helps prevent carburettor diaphragms sticking together.
• Thoroughly clean the machine- pay special attention to the cylinder fins and air filter.
• Store the machine in a dry, high or locked location - out of the reach of children and other unauthorized persons.
• Do not expose the container to direct sunlight for unnecessarily long periods. UV rays can make the container material
brittle, which could result in leaks or breakage.
Technical Data
Displacement: 43cc
Power: 1.7hp
Air outlet flow: 12m 3 /min
Air outlet speed: 4200m3/min
Tank capacity: 1.2L
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior
notice unless these changes significantly affect the performance and safety of the products. The parts described / illustrated
in the pages of the manual of the purchased product may also refer to other models of the manufacturer’s product range,
with similar features, other than the product you have purchased.
* Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty
will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement
work, including maintenance and special adjustments, must only be carried out by technicians of the authorized service
department of the manufacturer.