EN
G
LIS
H
31
①
Remove the tool according to the section " 7. CHANGING THE TOOL " procedure above and
remove collet nut assembly (Fig. 11).
②
The collet and collet nut are secured by a groove in the collet and a flange in the collet nut. To
remove the collet hold the collet nut in one hand and push diagonally down on the collet. The
collet should be released (Fig. 12).
③
To install the collet, hold the collet at a slight angle, and insert it into the collet nut (Fig. 13).
Press the collet in the collet nut by positioning the collet in the collet nut and pressing down on flat
surface (Fig. 12).
Be sure to fully engage the latch inside the collet nut into the groove on the collet's outer
circumference area (Fig. 14).
Loosen
Tool
8
5
Collet Nut
Spindle Shaft
Collet
Wrench Seat
Collet Nut
DOWN
Collet Nut
Collet
Groove
Latch
Latch
Fig. 11
Fig. 13
Fig. 12
Fig. 14
REPLACING THE COLLET
8.
When installing the collet into the collet nut, be sure to fully engage the latch inside the
collet nut to the groove on the collets outer diameter area. In addition, remember that if the
collet is attached without being engaged with the latch of the collet nut, the collet cannot
be removed and this may cause damage to the collet or the spindle.
CAUTION
OM-K0587 002_HES810_(A5x18)_EN_150205.indd 31
2015/02/05 17:24:48
