NAiS FP2, Technical Manual

Page: 7 / 144

Before You Start
CPU units
The CPUs as below are necessary to use this unit.
FP2: Ver. 1.50 or later
FP2SH: Ver. 1.50 or later
Note) The unit does not work due to the CPU error when using the older version than Ver. 1.40.
Programming tools
The programming tools as below are necessary to use this unit.
FPWIN GR: Ver. 2.40 or later
FPWIN Pro: Ver. 5.02 or later (Available soon)
FP2 communication block is necessary for FP2 Multi Communication Unit.
FP2 Multi Communicaction Unit cannot be used alone.
FP2 communication block must be installed for using FP2 Multi Communication Unit.
Difference from the conventional models
•
FP2-SDU
FP2-SDU and FP2 Multi Communication Unit is not interchangeable as all uses such as settings or
commands are different.
•
FP2-CCU
FP2-CCU and FP2 Multi Communication Unit is interchangeable, however, there are following
differences
- Unit number is available.
There is no unit number on CCU, but the unit number is avaialbe in the computer link mode of MCU.
(The default setting for the unit number is 1.)
- Command relay function (hierarchy function) for the network unit such as MEWNET-W.
It is not avaialbe for MCU.
- Data transmission by SEND (F145)/RECV (F146) commands.
It is not available for MCU.