Nagas ABE Series, Installation, Operation And Maintenance Manual

Page: 5 / 45

5 of 45
Installation, operation, and maintenance manual-ABE Rev 1_2023
2. GENERAL INFORMATION
2.1. INTRODUCTION
This manual has been produced to simplify the installation, maintenance, and operation of this equipment. Strict
application of these instructions will ensure that the installation complies with the manufacturer's
recommendations
.
The application of the instructions given in this manual is one of the conditions of the warranty, but it does not
guarantee at any time compliance with the applicable laws, rules, codes, and regulations of the country of
destination of the installed equipment.
This manual is protected by international copyright laws. No part of this manual may be reproduced,
distributed, translated, or transmitted in any form or by any means, electronic or mechanical, including
photocopying, recording, or recording in an information retrieval and archiving system, without the prior
written permission of the manufacturer.
2.2. RESPONSIBILITIES
This equipment must be used specifically for the purposes for which it was designed and manufactured. Any
contractual liability of
Nagas Express is therefore excluded in the event of injury to persons, animals, or damage
to the goods, resulting from errors in installation, adjustment, maintenance, or improper use.
Nagas Express is responsible for the compliance of the device with the codes and construction standards in force
at the time of sale. Knowledge of and compliance with the legal provisions as well as the standards inherent in
the design, implantation, installation, commissioning, or maintenance are the sole responsibility of the installer
or integrator.
Be aware that this manual does not cover all possibilities, situations, or contingencies. Regular service is required
to ensure the proper functioning and safety of this equipment. If you have any doubts about the performance
of these tasks yourself, you need to hire a qualified specialist. Negligence in maintenance may cause equipment
failure, property damage and/or damage to building occupants and will void the equipment warranty.
2.3. RECEPTION AND STORAGE
Upon receipt of the equipment, check that the packaging and contents have not been damaged during shipping.
Inspect the packaging for punctures or other signs of damage. Remove the packaging and check if there is no
external damage to the unit.
All units that leave our factory are tested and carefully inspected immediately prior to shipment to ensure they
are in good working order at that time. Check the packing slip to ensure that all parts for field installation have
been received. If damage is found or parts are missing, please contact your local authorized distributor or
representative.
If equipment must be stored before being installed on site, you should observe the following precautions:

Store in a well-drained, dry area that will not accumulate surface water to avoid damage from moisture in
wet soil, dew or rain.

Do not store in a location where equipment could be physically damaged.