SNUFFER SYSTEM
Insert the small plastic tube into the hole on the front of
the snuffer Using the 1/4-20 bolt and the two snuffer
eyes, which make up the bridle wire/tack fitting (1).
If you have the carbon snuffer pole, put the
extension and the long tube together to make
one long pole. Insert the snuffer head onto the
long end of the pole.
If you have the aluminum one piece pole, just insert the head onto the pole.
Slide completed snuffer assembly through the pole holder on the bridle/forestay connection, and over
the pin on the beam. Be sure that the protective covering on the pole is in the pole holder ring (2).
Attach the snuffer bridle wires to the forward tangs on the hulls, and tie them to the eye fitting on the
snuffer head as shown. Above (1).
Velcro the snuffer bag onto the pole, and tie the end of the bag to the pin on the pole with the small
line on the end of the snuffer bag (3).
INTER 17 SNUFFER SYSTEM DETAIL
Attach both the snuffer bridle wires to the same tang on the hull as the
forestay bridles, using the small bent tang supplied with the snuffer kit.
Be sure that the plate is on the outside of the hull tang between the
shroud adjuster and the tang (4).
Attach the pole holder to the thin white pole stay wire with the supplied
line, and to the pole bridle wires with clevis pins as shown (5).