233969 / 01/13 (A20)
16
Regular Maintenance
Once the clean-water tank has been emptied, the tank can be
removed.
Firstly detach the water feed pipe from the tap, this can be
done by pushing the red tap clip in whilst pulling off the pipe.
(Fig 35).
Removing the Clean Water tank
The black suction hose from the
floor-tool simply pulls off the floor tool
(Fig 36).
Inside the clean water tank is a filter,
located below the clean water inlet
(Fig 36a)
Clean all hoses and filters by flushing
with clean water.
Replacing the Clean Water tank
Fit the suction hose to the floor tool (Fig 37) and pass through
the hole in the clean water tank (Fig 37a).
Place the tank onto the machine base.
The water feed pipe simply
pushes onto the tap. (Fig 38a).
NOtE:
Ensure the water feed pipe locates in the channel
moulded into the base of the tank (Fig 38).
Replacing the Waste Water tank
Place the suction hose as shown
(Fig 39).
Place the tank onto the machine
(Fig 39a).
Refit the separator and reconnect the vacuum and suction
hose (Fig 40).
Fig 35
Fig 36
Fig 38
Fig 39
Fig 40
Fig 38a
Fig 36a
Fig 37a
Fig 37
Fig 39a
