1400 Fold Door System
www.NabcoEntrances.com
Part #15-9324
Rev. 11-26-14
5-17
Install the Folding Door
3. Go to the Bottom Rail. Locate (2) pre-drilled holes inside Web. Please see Figure 5-3.
4. Lay the Bottom Pivot (Door Portion) onto the Spacer. Align screw holes to the Web.
5. Secure the Bottom Pivot to the Spacer and to the Web within the Bottom Rail with (2)
1/4 - 20 x 1-1/4” Hex Screws.
DN 0330
1/4” Star Washer
Spacer for Bo om Pivot
Web
1/4-20 x 1/4” Hex Screw
Pivot S le
Bo om Pivot
Figure
5-3
Install Bottom Pivot Door Portion Assembly into Web
Sec on
5c:
Secure Spindle Drive Bar to Folding Door
Note:
The Drive Bar is installed to the Channel Guide at the NABCO Factory for shipping purposes only and
must be removed from the Channel Guide before the Folding Door can be installed.
1. Ensure the Pin or 1/8 inch Allen Wrench is still inserted into the Lovejoy Coupling Access
Hole. If not, please follow instructions listed in Section 3d; Steps 3 thru 4.
2. Go to the Spindle Drive Bar. Remove the Hex Bolt and Nut. Please see Figure 5-4.
a. Please refer to the Shipping Sticker located on the Spindle Drive Bar.
3. Release the Spindle Drive Bar from the Guide Channel.
a. The Spindle Drive Bar can be pushed up into the Header or down into the Top Web of the
Folding door, but will remain at a 90 degree angle.
b. The Guide Channel can now freely swing closed or open.
4. Swing the Guide Channel up against the Magnetic Latch.
Figure
5-4
Release Spindle Drive Bar from Guide Channel
DN 0844
Nut
Guide Channel
Spindle Drive Bar
Bolt
Spindle Drive Bar - 90 Out
(Lowered down from Header)
Guide Channel
90
Sec on
5d:
Secure Folding Door to Frame
1. With the Folding Door still on a lat surface, go to the Pivot End of the Top Web.
2. Remove (4) 1/4-20 x 3/4 inch Hex Head Screws and (4) 1/4 inch Star Washers from
Riv-nuts located inside the Web. Save hardware for reinstallation. Please see Figure 5-5.
