Rev. 11-26-14
Part #15-9324
www.NabcoEntrances.com
1400 Fold Door System
Install the Folding Door
5-20
Figure
5-9
Push Split Plastic Bushing around the Spindle
DN 0850
Split Plas c Bushing
Spindle
Guide Channel
Spindle Drive Bar
Sec on
5f:
Adjust Folding Door
Note:
Each Push Rod has been pre-installed at the NABCO Factory to ensure the Folding door will fully
close under normal operation. However, after installation adjustments may be necessary.
1. Go to the Push Rod that needs to be adjusted. Loosen both Hex Locknuts.
a. One Hex Locknut has left hand threads, the other Hex Locknut has right hand threads.
2. Turn the Push Rod clockwise or counterclockwise to lengthen or shorten the Push Rod until
the Folding Door can fully close with both door panels lat.
a. One end of each Push Rod has left-hand threads; the other end has right hand threads.
3. Re-tighten both Hex Locknuts. Do not overtighten.
Figure
5-10
Lengthen/Shorten the Push Rod
DN 0854
Hex Locknuts
Push Rod
Rod End
14
13
12
11
10
9
8
7
6
5
4
3
2
1
14
13
12
11
10
9
8
7
6
5
4
3
2
1
