1400 Folding Door System w/Opus Control
www.NabcoEntrances.com
Part #15-9324
Rev. 7-29-15
6-23
Install the Door Panel
2. Lift the Folding Door from the lat surface. Keep Door Panels loosely folded.
3. Tilt the Folding Door to slide the Spindle Drive Bar into the Pivot end of Top Web. The Spindle
Drive Bar can be pushed up toward the Header to allow clearance.
4. Upright the Folding Door to slide the Bottom Pivot onto the Pivot Bearing located inside the
Bottom Rail.
5. Go back to the Top Web. Lower the Spindle Drive Bar until it butts up against the Web.
6. Secure the Spindle Drive Bar to the Web with (4) 1/4-20 x 3/4 inch Hex Head Screws and (4)
1/4 inch Star Washers that were saved for reinstallation.
a. Do not tighten down bolts at this time. Bolts need to be loose enough to allow the Folding
Door to be adjusted.
Figure
4-6
Install Folding Door
DN 0848
Spindle Drive Bar
Pivot Bearing
Spindle
Drive Bar
1/4” Star Washer
1/4-20 x 3/4” Hex Head Screw
3.5
Secure Guide Channel to Folding Door
1. Manually hold open the Folding door while removing the Pin or 1/8 inch Allen Wrench from
the Lovejoy Coupling Access Hole.
2. Swing out and then lift the Guide Channel so it is directly on top of the Guide Roller located
inside the Top Web at the Strike end. Drop the Guide Channel onto the Guide Roller. Allow the
Folding door to close without slamming closed.
Figure
4-7
Drop the Guide Channel onto the Guide Roller
DN 0851
Guide Channel
Guide Roller
