18
10.
AUDIO DEVICES WITH CABLE CONNECTION
The range of N-Com products offers various “Multimedia Wire” accessories for
connection to external audio devices: MP3 players, i-Pods, Satellite navigators, GMRS
and PMR radio and audio systems pre-fitted on motorcycles (MCS).
To find out about all the available cables, please visit the website www.n-com.it in the
“Cable connection compatibility” section.
Note: Connect the 3.5-mm 4-pole connector of the Multimedia wire to the helmet
and the other end to the audio device. A coloured band on the cable indicates the
connector to be hooked up to the audio device.
Once it is turned on, cable connection stays active even in the subsequent menus.
Consequently, you can hear the device connected via cable even while listening to
music via A2DP or via RADIO.
11.
RIDER-PASSENGER INTERCOM MODE
In order to use Bluetooth kit3 in wireless intercom mode, both helmets have to be
equipped with a Bluetooth kit.
In order for two Bluetooth Kits to communicate with one another, they have to be
paired up first.
11.1.
Intercom affiliation
1.
Make sure both N-Com Bluetooth systems are turned off;
2.
Set both N-Com Bluetooth systems in Pairing up mode by pressing “on” (for more
than 4 seconds), until the LEDS start to flash quickly;
3.
On either one of the two helmets, press “on” briefly;
4.
After a few seconds, the helmets “recognize” each another, a beep is emitted to
signal the pair up was successful and intercom communication is activated;
5.
Turn off both N-Com Bluetooth systems and turn them back on to store the pair
up data.
