System Board
Section 1
Installation
Color or Mono Video Selection
Jumper
located in the lower left corner of the
board, is used set the type of video adapter. Placed
over the two pins (closed), indicates a color video
adapter is installed. Removed (open), indicates a
monochrome adapter is installed. If both a color and
mono adapter are installed, place the jumper in the
position to indicate which video adapter will be used
during boot-up.
Local Bus Jumper Settings
The following table details the Local Bus enable and
disable jumpers.
The following Local Bus adapters have been tested
and are recommended:
Eagle Mountain S3 card
Stealth Diamond S3 card
AIR S3 card/UTD S3 card
Weitek Power 9000
Alpha Research Corporation
DC-680 IDE caching controller
Ultrastor SCSI controller
Promise IDE controller
Version DO1
Copyright 1993
