Installation
Section 2
MVE466 System Board
Replacing
BIOS
the
Usually the system board is shipped with the
BIOS ROM chip already installed. If you must
replace the ROM chip, use these steps:
Check the
New BIOS
Verify that the BIOS to be installed is compatible
with the chip set and cache memory controller
installed on the system board.
Verify that the BIOS chip is a
27512
chip, with a 200 ns access time.
l
Verify that the BIOS chip is marked
BIOS.
Installing the
New BIOS
Locate where the chip is to be installed.
Make sure pin 1 on the chip corresponds to pin
1 of the socket by aligning the notch on the
chip with the silkscreened notch on the syslem
board. Make sure the chip faces the front of the
chassis (away from the I/O connectors). Align
the pins with the socket hole, then push the
chip down carefully until the pins are seated
securely in the socket. Be careful not to bend
any of the pins.
l
You are now ready to power up the system, and
run the SETUP Utility (see chapter 2 SETUP
for more information).
4 - 2
Version
Copyright 1993
