Mylex DAC960PG, Installation Manual

Page: 84 / 106

Installation
B-6 DAC960PG Installation Guide
3. Remove the protective pin cover and peel-off label from J1 on the
IBBU.
4. Leaving the 4 standoffs attached to the IBBU, remove a nylon screw
from the free end of each nylon standoff.
Figure B-3. Installing the IBBU onto the DAC960PG
5. Install the IBBU so that J1 on the IBBU connects to J5 on the
DAC960PG. Pin 1 on the IBBU’s J1 must connect to hole 1 on the
DAC960PG’s J5. The mounting holes on the IBBU will line up with
the mounting holes on the DAC960PG if the connectors are plugged in
correctly.
6. Be sure the 4 standoffs line up with the 4 holes in the DAC960PG.
Place a nylon screw through a hole from the back of the DAC960PG
into a standoff, and turn the screw to the right until it is snug (not too
tight). Repeat this step with the remaining 3 standoff screws.