the
Configure the board using the
configuration
for thin ethernet (also known as
Make
up a thin ethernet cable such as
(at least 15 feet or 5 meters in length) with a BNC
tee at each end, and a
ohm terminator on one
port of each tee. Attach one tee to the LAN adapter
to be tested, leaving the other end free and run the
program above. This
will check the
adapter base address and interrupt request line
against the configuration, test the dual ported
and run a loop-back test with the
and
nators attached. The test may also be conducted
by selecting the AUI or the
ethernet port
Select
Ethernet Port through
configura-
tion. Connect
a
thick ethernet transceiver to the
AUI port on the card. Also, the transceiver needs
to be cabled with a thivk ethernet cable and termi-
nated at both ends of the cable
Now
run the test. In order to test out the
port,
select the
port in the
configuration.
Connect the 1
port to a 1
concentra-
tor and run the test.
A-2
3.0
Copyright 1992
