Hardware
and
Ethernet
Adapter
During the
configuration
procedure, it is
advisable to
make a manual note of the configura-
tion
options selected. This information will be re-
quired during the installation of various operating
system drivers described in the following chapters.
In order to perform this function, the
Configu-
ration Utility refers to a special data base file that
describes the
and the possible options it
supports. This data base file (different for
and
is contained on the
LNE390 Driver Diskettes
format).
Refer to the host system’s documentation for in-
structions on how to start the
Configuration
Utility. These instructions also have instructions on
how to copy the configuration data base files to the
floppy diskette on which they will be used. As a
shortcut, however, it is possible to place the
Driver Diskette in Drive B, and the
Configuration Utility diskette in
A, and enter
the following DOS command:
COPY
A:\
This will place all the available files on the Configu-
ration Utility Diskette, which will make them avail-
able for use when the program is run.
When the
board(s) are recognized ‘by the
Configuration Utility, a configuration screen is
displayed. To configure the
board, move
the cursor to the board to be configured and press
the ENTER key. You will be given several options
for the
configuration.
Media
for the
If an
board
IS
being installed. the
Configuration Utility will provide the option of
2 . 4
3 0
1992
