Troubleshooting:
www.hygienesuppliesdirect.com
CAUSE
The nozzle is blocked.
The paint suction tube is blocked.
The small hole in the paint suction
tube is blocked.
Material adjustment knob turned too
far to the left (-).
The paint suction tube is loose.
No pressure is built up in the container.
The nozzle is loose.
The nozzle is worn.
Build up of coating material in the air
cap and nozzle.
Coating materials viscosity is too high
Too much material.
Material adjustment knob turned too
far to the right(+).
Nozzle dirty.
Air filter very dirty.
Not enough pressure built up in
container.
Refill
Clean
Clean or replace
Too much coating material applied
The distance to the object to be
sprayed is too large.
Too much coating material applied
PROBLEM
No coating material is
coming out of the nozzle
The coating material
drips from the nozzle
Spray too coarse
The spray jet pulses
Coating material in
container is running out.
The small hole in the
ascending pipe is blocked
Air filter very dirty.
Run in the coating
material
Too much coating material
mist (overspray)
REMEDY
Clean
Clean
Clean
Turn to the right (+)
Tighten the pipe
Tighten container
Tighten
Replace
Clean
Dilute
Turn material
adjustment knob
to the left (-)
Clean
Clean or replace
Tighten container
Turn the material
adjustment knob
to the left (-)
Reduce spraying
distance
Turn material
adjustment knob
to the left (-)
15
MYESG01_Paint_sprayer_Manual 22/12/16 08:56 Page 15
