www.hygienesuppliesdirect.com
Right Way (fig.11)
Always hold the spray gun at an even distance of approx. 5-15cm from the
object to be sprayed.
Move the spray gun evenly across or up and down,
depending on the adjusted spraying effect. An even movement of the
spray gun will give a uniform and even surface quality.
Wrong Way (fig.12)
Excessive paint mist will form an uneven surface finish.
If coating material builds up on the nozzle (2) and air cap (1) clean both
parts with solvent or water.
• Turn off device and unplug from power source.
• Place spray gun in spray gun holder.
• Remove parts for cleaning.
Closing down and cleaning:
1. Turn off device. Open trigger so that the coating material in the spray
gun runs back into the container.
2. Unscrew the container. Return the remaining coating material into the
material tin.
3. Clean the container and the paint suction tube with a brush.
4. Fill the container with solvent or water and screw back into place.
Only use solvent with a flash point of over 32
°
C
Turn on device and spray the solvent or water into a container.
Due to high air volume some solvent or water will be deposited outside
the container.
5. Repeat the above procedure until clear solvent or water comes out of
the spray gun nozzle.
12
! 1.000
!
1.000
!
1.000
13
MYESG01_Paint_sprayer_Manual 22/12/16 08:56 Page 13
