Connecting MYIRO-9 to Computer
▍
Setting Network Settings for Connecting MYIRO-9 to Computer via a LAN
The MYIRO-9 can be connected to a LAN and shared by multiple computers. When connecting the MYIRO-9 to a LAN, network settings
can be performed directly or DHCP (Dynamic Host Configuration Protocol) can be used.
• Network settings can also be performed from Measurement Utility Software FD-S2w when the MYIRO-9 is connected via USB.
Setting network settings directly
The IP address, subnet mask, and default gateway can be set directly in the settings screen.
• It is not possible to set the network name directly using the MYIRO-9 buttons.
1
Press
to open the settings screen.
2
Press
or
repeatedly to select “IP address” and press
.
The first number of the IP address will be highlighted.
• “IP address” will be disabled if “DHCP” is set to “ON”. To change the setting to “OFF”, see p.
3
Press
or
repeatedly to set the desired value for the first number.
• Holding
or
pressed will cause the value to change continually.
• Values between 0 and 255 can be set. If
or
is pressed again when the lowest or
highest value has been reached, the number will change to the highest or lowest value.
4
Press
to move to the next number.
5
Repeat steps 3 and 4 until all numbers have been set for the IP address.
6
Press
to select “Subnet mask” and press
. The first number of the
subnet mask will be highlighted.
7
Press
or
repeatedly to set the desired value for the first number.
• Holding
or
pressed will cause the value to change continually.
• Values between 0 and 255 can be set. If
or
is pressed again when the lowest or
highest value has been reached, the number will change to the highest or lowest value.
8
Press
to move to the next number.
9
Repeat steps 3 and 4 until all numbers have been set for the subnet mask.
24
