Cleaning
▍
Cleaning inside the MYIRO-9
If paper dust, etc. accumulates inside the MYIRO-9, it may cause paper jams or problems with patch recognition. If paper jams or patch
recognition problems start to occur more frequently, the inside of the MYIRO-9 should be cleaned according to the procedure below.
1
Make sure that the MYIRO-9 is switched off.
2
Disconnect all cables (USB cable, LAN cable, AC adapter cable).
3
Open the cover.
4
Loosen the two screws as shown completely so that they are
free of the base.
5
Close the cover.
6
Grasp the ends of the MYIRO-9 and tilt the MYIRO-9 body
backward as shown. The base should stay flat.
7
Clean the cover glass of the line sensor and the white backing
and other plastic surfaces with a clean, dry, soft, lint-free cloth.
• If the white backing is extremely dirty, clean the white backing with a soft
cloth moistened with alcohol.
8
Wipe off the rubber rollers with a soft cloth moistened with
alcohol to clean and condition them.
9
Grasp the ends of the MYIRO-9 and tilt the MYIRO-9 body onto
the base again.
10
Open the cover
11
Tighten the two screws as shown until snug.
• If the screws are loose when measurements are taken, measurement
accuracy may suffer.
• Do not overtighten.
12
Close the cover and reconnect cables.
36
