MyBinding Plockmatic BM 200, Installation Manual, Page: 45 / 53

1-40
31 January 2007
COM BM 200
COM SQF 20
COM BM 200
1.5.5 CONNECTORS
[B]
[A]
[C]
1. Move the Belt Stacker cable [A] to the SquareFolder (
x 1).
NOTE: Do not connect the Belt Stacker cable [A] to the Trimmer.
2. Move the Terminator plug [B] from the Trimmer to the SquareFolder (
x 1).
3. Install the COM. SQF 200 sticker [C], from the installation kit, over the “Termi-
nator” sticker on the Trimmer.
4. Install the Communication cable [D] between the Trimmer and the Square-
Folder (
x 1).
5. Mount the cable protector [E] positioned as shown with two screws in the
holes [F] and route the cables inside the cable protector (
x 2).
6. Attach the sticker “Do not lift here” [G] on the cable protector.
7. Install the cable holder on the rear side of the SquareFolder.
8. Route cables through the cable holders [H] on the rear side of the Booklet
Maker, Trimmer and SquareFolder.
SquareFolder
Trimmer without SquareFolder installed
[D]
SQUAREFOLDER INSTALLATION
Trimmer with SquareFolder installed
[G]
[E]
[F]