MyBinding Plockmatic BM 200, Installation Manual, Page: 31 / 53

1-26
31 January 2007
1.4.5 CONNECTORS
1. Connect the Belt Stacker cable [A] to the Trimmer (
x1).
NOTE: Unless a SquareFolder SQF 200 also will be installed. If so, the Belt
Stacker cable will connected to the SquareFolder instead.
2. Remove the Trimmer Terminator plug from the Booklet Maker [B] (
x1).
3. Connect the Trimmer Terminator plug on the Trimmer [C] (
x1).
4. Remove the Interlock jumper [D] from the Booklet Maker (
x1).
5. Connect the Interlock jumper to the Booklet Maker frame [E] ( x1) (see
next spread). This jumper will be stored in this area, it will be needed at a later
date to allow the Booklet Maker to function while the Trimmer is serviced.
6. Connect the communication cable to the Trimmer [F] (
x1).
NOTE: The communication cable you received with the Trimmer.
7. Connect, the other end of the communication cable, to the Booklet Maker [G]
( x1). (see next page)
8. Connect the powercord to the Trimmer [H] (
x1).
9. Connect, the other end of the powercord, to the Booklet Maker [ I ] (
x1)
(see next spread).
10. Mount the cable protector [J] positioned as shown with two screws in the holes
[K] and route the cables inside the cable protector (
x 2).
11. Attach the sticker “Do not lift here” [L] on the cable protector.
12. Install the cable holder on the rear side of the Trimmer.
13. Route cables through the cable holders [M] on the rear side of the Booklet
Maker and Trimmer.
[B]
[D]
Booklet Maker without Trimmer installed
Continued on next page....
TRIMMER INSTALLATION