58
20. CLEANING THE UNIT
20-5. Cleaning the Paper
Ejection Outlet Sensor
The paper ejection outlet of this unit has a
sensor for checking the paper ejection state.
This sensor may fail with the error message
“-J2-” when printing powder and paper dust
accumulate on it.
When this message appears, clean the sensor
with an Air Duster (a commercially available air
spray for eliminating dust for office equipment)
as well as a paintbrush, etc.
This sensor consists of two sensors located at
the top and bottom of the paper ejection outlet.
First clean the upper sensor and then the
lower sensor.
Disconnect control cord 1 of folding
plate 1 from the No.1 connector,
release the lock lever, and then remove
folding plate 1.
1
Cleaning the upper sensor
Lock lever
Folding plate 1
Insert the nozzle of the Air Duster into
the hole of the top cover R shown in the
figure, and spray briefly.
2
Set folding plate 1 back to the original
position.
3
Push the lock lever towards “LOCK”,
and insert control cord 1 into the No.1
connector.
4
Hole of top cover R
Cleaning the lower sensor
Disconnect control cord 2 of folding
plate 2 from the No.2 connector,
release the lock lever, and then remove
folding plate 2.
1
Lock lever
Folding plate 2
No.2 connector
Control cord 2
Insert the paintbrush straight in from
the hole of the power supply cover
along the guide, and gently clean the
top of the sensor with the brush.
2
Do not rub the top of the sensor with the
metal portion of the paintbrush, as this may
damage the film protecting the sensor,
causing sensor problems.
Note
Note
Set folding plate 2 back to the original
position.
3
Push the lock lever towards “LOCK”,
and insert control cord 2 into the No.2
connector.
4
Hole of power supply cover
Film
Paper ejection
outlet sensor
(lower side)
Hole of power
supply cover
Guide
Paintbrush
4.17"