25
-1
1
2
3
4
5
6
0
6
0
1
2
3
4
5
6
9. STANDARD FOLDING OF STANDARD PAPER
Set the paper feed pressure adjusting
lever to “0”.
Move the adjusting lever to the left and right while
pulling upwards.
If paper slips and mis-feed occurs, increase the paper
feed pressure by one from “0” to “1”.
Paper feed pressure increases as the scale value
increases.
If several sheets of paper are fed at the same time
(double-feed), decrease the paper feed pressure by
one from “0” to “–1”.
7
Top cover
Open the top cover, and set the
separating pressure adjusting dial to
“0”.
After setting, close the top cover.
If several sheets of paper are fed at the same time
(double-feed), increase the paper separating pressure
gradually in steps of 0.5.
Paper separating pressure increases as the scale
value increases.
8
Paper feed pressure adjusting lever
Press the folding mode key to select
the folding mode.
Each time the folding mode key is pressed, the
standard folding lamp lights up in order from the
leftmost single folding lamp towards the right.
If custom folding data is registered, the custom folding
registration lamp will automatically light up after the
standard folding lamp.
If not registered, it will not light up.
6
Custom folding
registration lamp
Standard folding lamp
Separating pressure adjusting dial
P r e s s t h e s p e e d k e y t o s e t t h e
processing speed.
When using thin and flimsy paper, setting the
maximum processing speed causes problems such as
paper jam and deformed folding. Set a lower
processing speed.
When the power is turned on, the last processing
speed used is displayed.
9
