MX Group Inspiration QI, Installation Instructions Manual

Page: 5 / 13

5. INSTALLATION
Position your shower unit on the wall away from the
direct spray of the shower and at about the same
height as the showerhead position.
The shower unit should be positioned so that the
showerhead cannot be immersed in the bath or
shower tray when hanging down.
Remove the four screws securing the shower unit
cover and remove the cover complete with the control
knobs.
Place the shower unit on the wall and mark the
location of the fi xing screws through the back plate.
Carefully drill the holes as marked using a sharp
5.5mm masonry drill after fi rst having made certain
there are no pipes or wires behind the proposed holes.
Fix the shower unit to the wall using the plugs and
screws provided, do not fully tighten at this stage.
Inspiration
QI
Phased
Shutdown Auto
Reset
Low
Eco
High
4. GENERAL LAYOUT OF A SHOWER INSTALLATION
A TYPICAL INSTANTANEOUS ELECTRIC SHOWER
INSTALLATION
Plan your own installation carefully. Check on the
nearest and most readily accessible rising mains
water supply, this may be beneath the bath or in the
loft, where it feeds the cold water storage tank. Use
only the cold rising water main supply.
Do not connect the shower unit to the outlet from the
cold water tank.
Avoid connecting the shower unit, if possible,
were it will be affected by water drawn off by other
appliances, e.g. From the mains feed to the W.C.
This may cause a drop in pressure too low for the
shower unit to work correctly.
An isolating valve must be fi tted to comply with water
regulations and for servicing purposes.
BATH
COLD WATER
MAINS SUPPLY
SEPARATE PERMANENTLY
CONNECTED SUPPLY
FROM CONSUMER UNIT
ISOLATING
STOP TAP
DOUBLE POLE
HEATER SWITCH
WALL MOUNTED
IN ACCORDANCE
WITH LOCAL
AUTHORITY
REGULATIONS
SHOWER
UNIT
BATHROOM
FLOOR
CEILING JOISTS
IMPORTANT
This appliance is not intended for use by persons (Including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
!

!
!

!
PRODUCT POSITIONING GUIDE
Shower unit can be mounted either
side of riser rail
Height of
showerhead
and shower
to suit user’s
requirements
Mains cold water supply
(either top, bottom, left,
right or rear entry
25mm minimum
Outline of bath or
shower tray
Spillover level
Spillover level
Soap dish
Hose retaining
ring