25
M1.1.SL30040-SL30040R.NLFREN 11122017
EN
TOOLS
7.2 Maintenance
IMPORTANT!
Always ensure that the hoist is not connected to a power source before starting any repair or
maintenance work.
• 1 cycle represents 1 lift movement with load. Periodic inspection refers to inspection after 100 cycles.
•
Regularly check if the hoist’s limit switch and floor braking mechanism are working properly. The following test should be
carried out: When the cylinder on the wire rope reaches the maximum height, the limit plate on the limiter should be in
contact with the push button on the junction box assembly, and the motor should stop. When the cylinder lands on the
ground, the limit plate on the floor braking mechanism should be in contact with the push button on the floor brake switch,
and the motor should stop (no load test).
• Check the power cables and control cables regularly.
• Regularly check if the various mechanical parts are loose.
• The hoist must be inspected once every 30 cycles, and the wire rope must be in good condition. If it is damaged, it must be
replaced with the wire rope stipulated in the technical data and must be securely fixed after replacement before using.
• Tighten the limit bracket, limit spring and limit plate screws after every 1,000 cycles.
• Check that the lifting hook and cylinder attached to the wire rope are in good condition after every 1,000 cycles, and are
not tangled or wound up.
• Before using the hoist, check if the emergency stop switch and button on the control handle are working properly.
• Check the braking system after every 1,000 cycles. If the motor generates abnormal noise or cannot reach the rated load,
the braking system may require overhaul:
- Replace any damaged or worn parts and keep relevant maintenance document safely.
- If any non-scheduled maintenance work is required, please contact an authorized service center.
7.3 Ordering replacement parts
Please specify the following information while ordering replacement parts:
• Hoist model
• Hoist number
• Hoist serial number
• Replacement parts required
8 Storage
Keep the equipment and accessories away from children and store in a cool and dry place. Ideal storage temperature is
between 5 °C and 30 °C. The wire rope hoist should be stored in its original packaging.
9 Disposal and recycling
• The equipment is packed to prevent damage while transporting. This packaging uses raw material which can be
reused or recycled.
• The equipment and its accessories are made of various types of materials, such as metals and plastics.
• Defective parts must be treated as special waste. Consult your dealer or your local council.
• Do not place any power tools in household waste.
• In order to comply with European Directive 2012/19/EV on old electrical and electronic equipment, and
implementation as per national legislation, old power tools must be separated from other waste, treated in an
environment-friendly manner and sent to a recycling station.
copyrighted
document
- all
rights
reserved
by
FBC