MV Agusta BRUTALE 910 S, Workshop Manual

Page: 85 / 112

Engine
- 69 -
B
Removing water pump
Work with cold motor.
Drain liquid.
A)Loosen the clamp and remove the coupling from the
cylinder group,being careful not to damage it.
B)Remove the screws (1) which fasten the pump body
to the bedplate.
C) Slide the pump out of the bedplate.
Disassembling water pump pieces
After having extracted the pump from
the bedplate disassemble the pump as
follows:
A)Remove the tightening screws from
the pump body (1) and separate the
latter from the cap.
Be careful no to let the two
centering bushes fall (9).
B)Remove the two O-Rings (2)
C)Remove the two seeger rings (3)
D)Take the impeller out (4) from its shaft
(5)
E)Separate the impeller (4) from its
shaft (5) by unscrewing.
During the following procedure
use the necessary precautions
so as not to get burned.