© MuxLab Inc.
6G-SDI Extender Over FIBER
Page 13
Simplex Connection:
If transmission is only required in one direction, this device can be
connected with a single fiber in a simplex arrangement as indicated
in the following steps below.
1.
While looking at the unit from the top, connect the single
fiber cable to the Transmitter right most LC connector as
shown below.
2.
While looking at the unit from the top, connect the opposite
end of the fiber cable to the Receiver left most LC
connector as shown below.
3.
The unused LC connector on both the Transmitter and
Receiver must be protected from dust. This can easily be
accomplished by cutting the protective rubber plug in half
and inserting the plug into the unused LC connectors.
Important note:
The serial port is not available when only using a
single fiber cable in a simplex arrangement.
