MUTOH Spitfire 65, Maintenance Manual

Page: 312 / 319

Spitfire – Maintenance Manual
312
AP-74096, Rev. 1.0, 09/06/05
3 The cutting operation
is in process, but the
paper has not been
cut. (1) Check the cutter blade for
shipping and deterioration. • Replace the cutter.
→
User’s Guide
4 The paper has not
been cut as smoothly
as expected,
resulting in jamming. (2) Check if the cutter cap is
securely installed. • Reset the cutter
cap securely.
→
User’s Guide
(3) Check if the cutter moves
up and down smoothly. • Reinstall the cutter
spring. -
(4) Check the cutter grooves
for accumulated paper dust
and slips. • Remove the
accumulated paper
dust along the
direction of the
grooves.
→
User’s Guide
(5) Check if the cutter blade is
parallel with the groove. • Make adjustments.
→
Replacing the
cutter holder, cutter
spring, cutter cap,
solenoid assembly
and solenoid spring.
(1) The sub-platen (cutter
groove) requires daily
maintenance. • Clean the surface
of the sub-platen 5 The cutting operation
is in process but the
paper does not fall
off.
(2) The sub-platen, paper
guide or the paper may be
charged with static electricity. • Provide a proper
ground.
• Check and adjust
the ambient
humidity so that it
meets the normal
operation conditions
of the product and
paper. -
(1) Check the cutter blade for
chipping and deterioration. • Replace the cutter.
→
User’s Guide
(2) Has the cutter cap been
securely installed? • Reset the cutter
cap securely.
→
User’s Guide
(3) Check if the cutter moves
up and down smoothly. • Reinstall the cutter
spring. -
(4) Check the cutter grooves
for accumulated paper dust
and slips. • Remove the
accumulated paper
dust along the
direction of the
grooves.
→
User’s Guide
(5) Check if the cutter blade is
parallel with the groove. • Make adjustments.
→
Replacing the
cutter holder, cutter
spring, cutter cap,
solenoid assembly
and solenoid spring.
6 Inaccurate paper
cutting
(6) The cutter may have a
problem. • Replace the cutter.
→
User’s Guide
(1) Check the operation panel
and make sure the InkDryTime
has not been set. • Change the
settings.
→
User’s Guide
7 Cutting starts after
the completion of the
print.
(2) Check the LCD and see if
messages for an analysis have
been displayed. • Printing data
remains.
→
User’s Guide