MUTOH Spitfire 65, Maintenance Manual

Page: 190 / 319

Spitfire – Maintenance Manual
190
AP-74096, Rev. 1.0, 09/06/05
5.9.3. Cutter Endurance menu
This menu performs endurance running for the cutter.
You can perform the cutting operation according to the settings.
Caution :
Pay attention to the following points when performing the cutter endurance operation.
¾
Install usable ink cartridges.
¾
Make sure that media initialization is complete.
Performing the cutter endurance operation without ink cartridges could result in damage
to the product if the cutter fails outside the cutting range.
The available settings are shown below.
Setup item Description Parameters Remarks
Page size Sets amount of media feeds per
endurance operation. 30 to 3000 Unit: mm
Number of endurance
running cycles Set the number of endurance
running cycles -1 to 10000
Waiting time Set the waiting time after one
cycle of endurance running 40 Unit: second
Notes :
¾
If the number of endurance running cycles is set to -1, the units continuously repeat
endurance running until a key input is given from the operation panel.
¾
The maximum counter value for endurance running cycles is 99999999 (up to 8-digit
number). If the number of cycles exceeds the maximum value, the counter is reset
to 0.
¾
The waiting time is not modifiable.
* Page size *
30 – 3000 mm + Page size
30 mm -
↓
ENTER
* Cutter *
Count
-1
→
10000 +
Count Endurance
50 -
↓
ENTER
* Cutter *
Time Wait (sec) 40 Check Waiting time
↓
ENTER