MUTOH Spitfire 65, Maintenance Manual

Page: 195 / 319

Spitfire – Maintenance Manual
195
AP-74096, Rev. 1.0, 09/06/05
5.9.8. Sequential Printing Endurance Menu
This menu performs endurance running for the printer heads.
You can operate the printer heads according to your desired settings. The available settings are shown
below.
Setup item Description Parameters
Printing mode Set printing mode. MODE 1, MODE 2, MODE 3,
MODE 5, MODE 6, MODE 7
Media Cut Sets whether to cut media each time one
printing is printed out or not. Yes, No
Number of endurance
running cycles Set the number of endurance running cycles -1 to 10000
Notes :
¾
If the number of endurance running cycles is set to -1, the units continuously repeat
endurance running until a key input is given from the operation panel.
¾
The maximum counter value for endurance running cycles is 99999999 (up to 8-digit
number). If the number of cycles exceeds the maximum value, the counter is reset
to 0.
* Print Mode *
F1
→
MODE1 MODE2
←
F2
F3
→
MODE3 MODE5
←
F4
(1/2)
* Print Mode *
F1
→
MODE6 MODE7
←
F2
(2/2)
↓
Select mode
* Cut *
Cut Yes/No +
Yes -
↓
ENTER
* Nozzle *
Count
-1
→
10000 +
Number of endurance running cycles
50 -
↓
ENTER
* Nozzle *
Count 5 Perform endurance running
↓
ENTER or CANCEL
* Nozzle *
End 50