MUTOH Spitfire 65, Maintenance Manual

Page: 271 / 319

Spitfire – Maintenance Manual
271
AP-74096, Rev. 1.0, 09/06/05
(2) Check the
P_REAR sensor
assembly for the
contact condition. •Redo the
connections of
Mainboard
assembly
connectors J128
and J129. If the
paper is not
initialized, the
sensor may be
damaged.
• Replace the
P_REAR sensor
assembly.
→
Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
→
Replacing the
P_REAR_R
sensor assembly
and P_REAR_L
sensor assembly.
been set to the up
position.
(3) The Mainboard
may be damaged. • Replace the
Mainboard
assembly.
→
Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
(1) Check the ink
end via “Test:
Sensor” of the self-
diagnostic
function. • Operate the lever
at the end
detecting element
of the ink sensor
assembly to check
if the ink end
indication
changes. (At this
time, the sensor
for detecting the
presence of
cartridges is set to
Yes.)
If there is no
response, replace
the ink sensor
assembly.
→
Sensor menu
→
Replacing the
I/H (ink holder)
assembly
5
6 [ ] Near End
[ ] Ink End The remaining
amount of ink is low.
Printing is still
possible.
There is no more ink
left. Printing in
progress is
interrupted
immediately.
(2) Check the ink
sensor connector
for the contact
conditions. • Redo the
connections of the
following
connectors.
• Junction board :
J401 – J418
• Mainboard : J133
– J134
→
Replacing the
Junction board
assembly.
7 Not Original
Ink
(1) Check the ink
end ID via “Test:
Sensor” of the self-
diagnostic
function. (This is
limited to when
smart chips are
set.) • If the type of the
installed cartridge
does not match the
displayed type, the
ink ID sensor may
be damaged.
→
Sensor menu