User’s Guide Spitfire 65/90 Extreme
CHAPTER 6 : PRINTER MENU
84
AP-75197– Rev. 1.2
6.5 OPERATION PANEL AFTER PRINTING
The operations performed after printing, are described here.
6.5.1 Cut off media with the printer knife
The media cutting procedure is described below.
Roll media is automatically cut after printing when "Auto" is set on the cut media menu and roll media has
been set.
When the operation panel is in the main screen, and the product is in the following conditions, the media can
be cut on the desired position:
When roll media has been set:
If "OFF" is set on the cut media menu
If "Take Up Roll" has been set in the media detection setup menu
When sheet media has been set
Follow the steps below to cut the media.
Follow the steps below to cut the media.
Step 1 :
Make sure that the MEDIA SET lamp on the operation panel is OFF.
Step 2 :
Press the [F1] key on the operation panel to shift to the cut and feed menu.
Step 3 :
Feed media to the desired position using the [F3] and [F4] key.
Step 4 :
Press the [F1] key to cut the media.
Press the [ENTER]-key to cut the media or the [CANCEL]-key to abort this operation.
Notes
If the front edge of the roll media is not straight when you load new roll media, you should cut
its edge.
Cutting blades are consumable. Replace them at regular intervals following "Replacing the
cutting blade".
Summary of Contents for Spitfire 65 Extreme
