Murex Tradestig AC 220, Instruction Manual And Spare Parts List

Page: 7 / 48

-- 7 --
bt38m1ea
5.1 Lifting instructions
Install the carrying strap as
illustrated and lift the power source
by the strap.
5.2 Location
Position the welding power source such that its cooling air inlets and outlets are not
obstructed.
5.3 Mains supply
Note!
Mains supply requirements
High power equipment may, due to the primary current drawn from the mains supply, influence the
power quality of the grid. Therefore connection restrictions or requirements regarding the
maximum permissible mains impedance or the required minimum supply capacity at the interface
point to the public grid may apply for some types of equipment (see technical data). In this case it
is the responsibility of the installer or user of the equipment to ensure, by consultation with the
distrubution network operator if necessary, that the equipment may be connected.
Check that the welding power source is connected to
the correct mains power supply voltage, and that it is
protected by the correct fuse size.
A protective earth connection must be made in
accordance with regulations.
Rating plate with supply connection data
Recommended fuse sizes and minimum cable area
Tradestig AC 220/ AC 220a TIG MMA
Mains voltage
230 V
¦
10 %,1
μ
230 V
¦
10 %,1
μ
Mains frequency 50 Hz 50 Hz
Mains cable area mm
2
3G2,5 3G2,5
Phase current I
1eff
14 A 15 A
Fuse
anti--surge
type C MCB
16 A
16 A
16 A
16 A
NOTE! The mains cable areas and fuse sizes as shown above are in accordance with Swedish
regulations. Use the welding power source in accordance with the relevant national regulations.
GB