Notice
Continued from the preceding page.
[Sizes: 1205(3212M) / 1206(3216M) / 1806(4516M)]
Bonding agent
Coating position of
bonding agent
The flux in the solder paste contains halogen-based
substances and organic acids as activators.
Strong acidic flux can corrode the capacitor and degrade
its performance.
Please check the quality after mounting, please use.
6. Reflow Soldering
o
Set temperature and time to ensure that leaching of the
terminations does not exceed 25% of the chip end area
as a single chip (full length of the edge A-B-C-D shown at
right) and 25% of the length A-B shown as mounted on
substrate.
[As a Single Chip]
[As Mounted on Substrate]
5. Flow Soldering
A
B
C
D
Termination (Outer Electrode)
A
B
4. Flux for Flow Soldering
1. An excessive amount of flux generates a large quantity of
flux gas, which can cause a deterioration of solderability,
so apply flux thinly and evenly throughout. (A foaming
system is generally used for flow soldering.)
2. Flux containing too high a percentage of halide may cause
corrosion of the terminations unless there is sufficient
cleaning. Use flux with a halide content of 0.1% max.
3. Strong acidic flux can corrode the capacitor and degrade
its performance.
Please check the quality of capacitor after mounting.
3. Adhesive Curing
1. Insufficient curing of the adhesive can cause chips to
disconnect during flow soldering and causes deterioration
in the insulation resistance between the terminations due
to moisture absorption.
Control curing temperature and time in order to prevent
insufficient hardening.
Continued on the following page.
(2) Use the following illustration as a guide to the
amount of adhesive to apply.
Cross Sectional View
Side View
Resist
Adhesive
Land
Board
<Applicable to NFM Series>
[Sizes: 0603(1608M) / 0805(2012M) / 1206(3216M)]
!
Note
• Please read rating and
!
CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
