Click on
Connect
to open the
Select Comm Port Settings
dialog box, as shown in Figure 8.6.2. If necessary, set the baud
rate to 9600 bps. Set the
CommPort
to match the serial port connected to the Base, either the hardware port or the USB
virtual serial port. Then click
OK
to activate the serial connection.
Figure 8.6.2
At this point the utility program will collect data from the Base, filling in the
Local Radio
column as shown in Figure 8.6.3.
Next, power-up the Remote using a wall-plug power supply. The Remote will transmit a “heartbeat” message on power up
as shown in the
Status Window
. Click on the drop-down box at the top of the
Radio 1
column and load the
MAC Address
for the Remote from the heartbeat message. Next press the
Start
button using the default 1 second
Refresh Delay
.
Figure 8.6.3
©2012 by Murata Electronics N.A., Inc.
DNT90M Integration Guide (2012/09/17)
Page 55 of 74
www.murata.com
