© Munters AB, 2013
17
5.5 Placement of fans
fig.12
fig.13
5.6 Electrical wiring
The fan is delivered without an electrical control box, but the fan motor comes already wired. Connection to the
power supply must be done by means of a thermal overload protection switch, whose size depends on motor
power. For safety reasons the overload switch can be locked by a padlock, not supplied by Munters.
In order to comply with CE regulations, fans should be mounted so that the bottom
of the fan is 2.7m or higher from the floor below it. If the fan is to be installed
at a lower height it should be equipped with special safety meshes which are
available as an optional extra.
note
If the MFS is installed near a wall or similar obstacle, a free space at least of
1,500mm should be left open on the fan air intake side.
note
Installation
Chapter5
min. distance = 1,500m
!
!
